im in need of a schematic if anyone has one I would appreciate it.
↧
XForce XT400
↧
RocketBox HD500 w/9530 FETs
Anyone have any input on these units.
Says can do HD input up to 50w..
Uses Palomar 9530 FET x4
Ratings say upto 25w in with 100w out
Builder says upto 55 amp draw. Has auto SSB like old Palomar units.
Units are $370 shipped. (About $120 less than a TS500HDV..)
Was entertaining for my AT-6666 as it does 40-50w peak.. mainly SSB.
Builder says 50w input for max output and should reach 450-500w.. says AM dk is 2-5w and swing up from that.
They also now offer a 2x4 LD model for $430 or...
RocketBox HD500 w/9530 FETs
Says can do HD input up to 50w..
Uses Palomar 9530 FET x4
Ratings say upto 25w in with 100w out
Builder says upto 55 amp draw. Has auto SSB like old Palomar units.
Units are $370 shipped. (About $120 less than a TS500HDV..)
Was entertaining for my AT-6666 as it does 40-50w peak.. mainly SSB.
Builder says 50w input for max output and should reach 450-500w.. says AM dk is 2-5w and swing up from that.
They also now offer a 2x4 LD model for $430 or...
RocketBox HD500 w/9530 FETs
↧
↧
Thinking about adding a small amp to my uniden 980.
Good evening Radio Friends,
Well I'm thinking about adding a small amp to my radio setup in my car. The amp I'm looking at is a Texas star modulator V- plus v with a set of 2879 transistors, it does 100 watts max, the power is variable and has auto SSB built in,there only asking $189.00 + free shipping and it's in my price range! What I need to know(since it's been about almost 15 years since I ran a amp) yes I know it's illegal, but what I need to know is if I can just plug and play so to...
Thinking about adding a small amp to my uniden 980.
Well I'm thinking about adding a small amp to my radio setup in my car. The amp I'm looking at is a Texas star modulator V- plus v with a set of 2879 transistors, it does 100 watts max, the power is variable and has auto SSB built in,there only asking $189.00 + free shipping and it's in my price range! What I need to know(since it's been about almost 15 years since I ran a amp) yes I know it's illegal, but what I need to know is if I can just plug and play so to...
Thinking about adding a small amp to my uniden 980.
↧
Do I have these gamma matches in the right place
The instruction pic says it's rotated 180 degrees for clarity. Well, it's messing with me. Having trouble getting tuned. I had the flat side tuned good, but the vertical stays above 1.8:1. Strange, the other day the vertical was low.
To me, it looks like both coax connectors are on the same side of the boom, but mine aren't.
To me, it looks like both coax connectors are on the same side of the boom, but mine aren't.
↧
Opinions and General Information for Newcomer
I am new to the art of HAM radio and know I have a lot to learn hence my reason for being here. Just a little background. I worked with my hands all my life and rarely took anything to a repair shop as I was able to fix most things on my own. Now days not so much. Diabetes took a good portion of my eyesight. It is my fine vision that is affected the most. It has slowed me down but not stopped me. Anyway, I have been researching HF antennas for my Yaesu FT-450D HF radio for about three weeks....
Opinions and General Information for Newcomer
Opinions and General Information for Newcomer
↧
↧
Tower accident
↧
Antenna mount
I'm looking for a front bedrail mount for my SS steel whip to install on my '13 Silverado. I've looked at Bleedlove but those are expensive! Anyone have a link to something that will work and is cheaper?
Thanx!
Thanx!
↧
RM Italy KL 503 HD - Anybody ever use?
I'm considering the RM / KL 503 HD. Anyone here have any experience with these and what do you think of them? Thanks !
View attachment 30437
↧
Northstar NS9500
My rf power is fluctuating from 1/2 to 12 watts . I set the dead key on 2 1/2 watts to drive my amp. Could this be a bad final? Or a bad capacitor? I have not opened the radio yet. I suspect it could be a capacitor near the voltage regulator. Cb tricks symptoms and cure database has been down for weeks . (EPT360014B)
↧
↧
Sidewinder 350 / sd1076 transistors
Any information on the sidewinder 350 would be great. Also need the transistor rating specifications. Take a look at it. Looks like it got pretty hot..
↧
WDX Roster
Here is the WDX Roster:
Please include your first name, town (if you fell comfortable with that) and State / Province when requesting.
I will make changes as needed...please check your listings and reply to this thread with any changes.
Edit by Binrat
Last Mod May 31, 2019
Please include your first name, town (if you fell comfortable with that) and State / Province when requesting.
I will make changes as needed...please check your listings and reply to this thread with any changes.
Edit by Binrat
Last Mod May 31, 2019
↧
Anytone AT-5555n
Selling my BARELY used AT-5555n. It is in perfect condition. I only converted it. No twisty turny goofball adjustments.
Rig will ship priority mail with original box and all original accessories. I just don't like it as much as my At-6666.
$165 within CONUS only
PayPal friends and family or USPS money order. I usually ship same or next day. View attachment 30477 View attachment 30478 View attachment 30479 View attachment 30480 View attachment 30481 ...
Anytone AT-5555n
Rig will ship priority mail with original box and all original accessories. I just don't like it as much as my At-6666.
$165 within CONUS only
PayPal friends and family or USPS money order. I usually ship same or next day. View attachment 30477 View attachment 30478 View attachment 30479 View attachment 30480 View attachment 30481 ...
Anytone AT-5555n
↧
Tower down ,
View attachment 30472
View attachment 30473
View attachment 30474
View attachment 30475
Had a bad storm hit our town a couple weeks ago,, 80+ mph straight winds they called it, and the neighbors tree came down on my garage roof and Tower,
got the house all fixed and cut up the tower for scrap. lost my A-99, 6m beam, 2m beam, scanner antenna, and the tower was supporting my all band 80m doublet fed with 600ohm true ladder line
no plans to get a tower back up yet...
Tower down ,
Had a bad storm hit our town a couple weeks ago,, 80+ mph straight winds they called it, and the neighbors tree came down on my garage roof and Tower,
got the house all fixed and cut up the tower for scrap. lost my A-99, 6m beam, 2m beam, scanner antenna, and the tower was supporting my all band 80m doublet fed with 600ohm true ladder line
no plans to get a tower back up yet...
Tower down ,
↧
↧
Dead Key vs Big Swing
I have researched this forum and other CB forums and this topic has peaked a curiosity question. I am not a radio technician and have only considered CB radio a hobby for the past 18 months.
My question is if I have two Cobra 29s with the same microphones, same antenna, coax setups with acceptable SWR. The first Cobra 29 is stock, but tuned and aligned properly DK 4 watts with a 3:1, 4:1 modulation. The second Cobra 29 has been mod to DK 2 watts and swing to max output. Will one of...
Dead Key vs Big Swing
My question is if I have two Cobra 29s with the same microphones, same antenna, coax setups with acceptable SWR. The first Cobra 29 is stock, but tuned and aligned properly DK 4 watts with a 3:1, 4:1 modulation. The second Cobra 29 has been mod to DK 2 watts and swing to max output. Will one of...
Dead Key vs Big Swing
↧
The MOD
I'm sure many of you remember the "MOD" where 'weakstation' came up with a control circuit using EPROMs to control the PLL and VCO. Lots of channels for different MB8719 chassis.
Pretty much forgot about this till today as I was doing a search for my old Geocities page. The front page is gone but some of the secondary pages still float around!
One of my pages I found to be connected to the old MOD page and thought I would add it here for at least posterity!...
The MOD
Pretty much forgot about this till today as I was doing a search for my old Geocities page. The front page is gone but some of the secondary pages still float around!
One of my pages I found to be connected to the old MOD page and thought I would add it here for at least posterity!...
The MOD
↧
Cushcraft PD-2 Power Devider ???
If I was to use a power divider on my Cushcraft 148-20T, would both planes need to be tuned the same? Say, if the flat side is tuned to 144.200 and the vertical is tuned to the upper portion of the band, what will I see at the radio? If I'm transmitting on 147 ish and my vertical SWR is flat, but at 144 ish the flat side is 1.8:1, what will that mean? Or, vise versa, I'm working SSB with a near flat SWR horizontal, but the vertical plane sees that high.... The documentation says I'll lose 3...
Cushcraft PD-2 Power Devider ???
Cushcraft PD-2 Power Devider ???
↧
SBE LAND COMMAND MODEL LCBS-8 AM/SSB BASE
Please I need any and all help with this radio, This is the last model SBE made, Big AM/SSB Base with digital clock. The radio works 100% and is in mint condition, but I can't find anything on THIS model on the what is the pin out on the microphone connector (5 pin screw on type), also radio has no recieve unless the microphone is plug in to the radio! Any and all help will ge great! I guess this radio is rare enough that no one has the manual or info on it. I have a Sure 526, 6-wire D104 ot...
SBE LAND COMMAND MODEL LCBS-8 AM/SSB BASE
SBE LAND COMMAND MODEL LCBS-8 AM/SSB BASE
↧
↧
Rci2990 no display or lights only white noise
I have an Rci2990 that was working perfectly. I moved it from one room to another room . Plugged it in and nothing on the face works . No lights on frequency counter , key pad , or meters . The frequency counter is also blank and it doesn't receive or transmit. Only white noise from the speaker .The tx light comes on when i power it up and the cooling fans are working . Ive checked voltage to the board and also even tested it with another power supply . Anyone has any ideas of where to start...
Rci2990 no display or lights only white noise
Rci2990 no display or lights only white noise
↧
My homemade dipole, success, but,,,,,,,,,
hi, this is my second time of making a dipole antenna and this one is a success.
It’s made out of some spare RG8U. I had it 18 feet in length and then I trimmed off 1 inch at a time on each end until I got to 1.5 on channel one, and 1.5 on channel 40.
I was afraid to go further. Is this about what I should expect? It’s about 10 feet off the ground on a pole temporarily. I’m going to climb a 36 foot tower and put it in the top tomorrow. By sliding it in the z and then using U bolts...
My homemade dipole, success, but,,,,,,,,,
It’s made out of some spare RG8U. I had it 18 feet in length and then I trimmed off 1 inch at a time on each end until I got to 1.5 on channel one, and 1.5 on channel 40.
I was afraid to go further. Is this about what I should expect? It’s about 10 feet off the ground on a pole temporarily. I’m going to climb a 36 foot tower and put it in the top tomorrow. By sliding it in the z and then using U bolts...
My homemade dipole, success, but,,,,,,,,,
↧
Tram D201 external VFO low output
i connected a siltronix 90-3 vfo. to Tram #1 i removed the ch23 crystal, and soldered the center of the cable to the bottom (power side) of the channel 23 socket and grounded it away from the socket.Going through the vfo on ch23 I tuned c711 and c712. On am it is getting 1 1/2 watts and a swings to 3watts on ssb it is swinging about 2watts. the reading off the vfo on ch20 is 5watts with a swing to 12watts on am and a 10watt swing on ssb
↧